Wilson Combat ARMOR-TUFF® Finishes #shorts

Hundreds of ARMOR-TUFF® Finish combinations available for rifles and handguns.

ARMOR-TUFF® Protective Firearms Finish was developed specifically for firearms use to provide a non-reflective tactical surface finish with optimum corrosion protection, abrasion resistance and enhanced lubricity. The low curing temperature prevents parts damage or warping during the finishing process. A firearm finished with ARMOR-TUFF™ has the most durable, chemical and heat resistant, thermally-cured firearm finish available.

Before a firearm is coated with ARMOR-TUFF® the firearm is thoroughly sand blasted with fine grit media, then carefully dehorned and every surface prepared by hand. Every carbon steel firearm is phosphate parkerized before we apply the final finish to form a bonding surface for ARMOR-TUFF® that increases durability and corrosion resistance.

A highly trained finish technician then sprays the ARMOR-TUFF® coating on the firearm before it is thermally cured. After the firearm is re-assembled it is given a thorough inspection to ensure the finish meets our highest standard of quality and ensure your firearms reliability.

Very attractive, non-reflective matte surface finish that looks very similar to an ultra-fine sandblast blue job.
Available in Black, Burnt Bronze, Flat Dark Earth, OD Green, Gray and Coyote Tan. We can also do various combinations of these colors. Check below for examples of different color combinations.
Can also be applied to Stainless Steel and Anodized Aluminum.
When applied to parkerized carbon steel, will pass the test procedures for salt water spray testing without corrosion for over 3000 hours! Properly coated surfaces will not rust when subjected to normal firearm use.
Provides excellent anti-friction characteristics over typical firearms finishes. We do, however, still recommend a quality lubricant like ULTIMA LUBE II be used on contact surfaces.
Will meet or exceed 24-hour immersion requirements in the following fluids: aviation gasoline, hydraulic fluid, jet fuel, lubricating oils, paint removers, trichloroethylene, hydrochloric acids, hydrogen peroxide, gunpowder solvents, common gun lubricants, strong bases, and numerous other chemicals.
Will withstand exposure to temperature extremes of +1000 degrees F to -250 degrees F.
Has a nominal thickness of between .0003″ and .0009″. The thin coating characteristics of less than one thousandth of an inch allow easy re-assembly of precision fitted parts.
Is applied at our finishing facility in Berryville, Arkansas, under the strictest quality control standards by Master finishing technicians and gunsmiths with years of experience.
Due to the nature of true custom hand crafted finishes. variations in color and pattern will occur. These are only visual representations and not identical references of the final product.

#WilsonCombat #ARMOR-TUFF

www.wilsoncombat.com/all-about-our-finishes/