How To Bleed Your Unit 2021!

**21+ Educational Purposes Only****Nothing For Sale**This video and it's statements have not been evaluated by the FDA and are not intended to diagnose, treat, or cure any disease or ailments**

Is your unit not holding pressure like it use to? Maybe it's time to bleed your unit! Follow these couple steps and you'll be smashing again in no time!

BLEEDING INSTRUCTIONS:

1. Make sure your unit is shut off and the release valve is tight to the right (clockwise). Be sure that your plates are not under pressure at this time (PLATES WIDE OPEN).

2. Close the plates leaving a 1/4" gap and keep the jack handle in an upward position. (PUMPING HANDLE ALL THE WAY UP)

3. Flip your unit upside down, wait one minute. Pump the handle downwards (up because the unit is upside down) ensure the handle stays in that position until the unit is flipped to its upright position.

4. Open the release valve and let the plates drop to the bottom (up) and ensure they're fully open. (Unit is still upside down at this point)

5. Once the plates are fully open, close the release valve tight to the right (clockwise), you can now turn the unit back to it's upright position (holding the pumping handle in the down position as in step 3),

6. It's okay to raise the pump handle now once the machine is in its upright position, test your unit by bringing the plates together nd check pressure.

7. Repeat these steps if necessary. If you have attempted this twice with no change, please contact us for further assistance at https://nugsmasher.com/contact/

NugSmasher- Rosin Made Simple!