G2 Extruder Stepper Motor Replacement

It seems that the failed extruder cooling fan caused the extruder stepper motor to fail.

After the failed extruder cooling fan caused the hot end to overheat, the stepper motor started acting up. If would make a loud buzzing sound at slower speeds and ultimately stopped turning at all. SO it was time to replace that part.

I found that setting 3.0mm of exposed shaft beyond the end of the extruder drive wheel worked well.

New stepper motor from:
https://solidstateprinters.com/

Subscribe for more content like this
Comment, rate, share & click the bell icon
And as always, thanks for watching

Intro/Outro:
Louisiana Fairytale by Austin Rogers
https://web.archive.org/web/20170402222425/http://drfiddle.com/show_tune.php?id=94