Adding Exhaust System to Case

In this video we show how we added the exhaust fans to the case so when closed it will take any heat internally after it reaches a certain temperature. We used a 3/8 drill bit for the large holes and 11/16 for the 4 bolts per fan. The reason the guard is on the inside is because the bladed are open so they can act as an exhaust fan and need to be protected from anything roaming around in the case. For the Temp Controller. just like we did for the monitor we drilled holes all around and cleaned it up using a box knife. Also, for the lamp we used a 5/8 key hole drill bit.

The complete circuit can be found on facebook https://www.facebook.com/minisolargenerator/posts/pfbid05czrbrsudaCc3TzsLXDd7jXH5SpZ9GSZcneE1Nr1xHZfnsVV3SBamDiKwcB9Dnzrl

If you can help, we would truly appreciate and need it -- Thank you https://gofund.me/5b4a16c6 Any little bit helps and we truly are grateful.

Fans https://amzn.to/3dvKuv2
Temperature Controller https://amzn.to/3Qqt3ei

These items are listed for your convenience to see the parts and get an idea. If you choose to purchase I do earn a few cents but has no additional cost to you.

#educate #Solar #portable #generator #youth #science #project #build #lifepo4battery #exhaust #fan #temperature_controller #batteryevo #renogy #victron #overkillbms