How To Make A Display Stand - Fusion 360 to Lightburn - XTool D1 Pro 20W Diode Laser

A knife like this one needs a proper stand!

⭐File Downloads - https://www.etsy.com/shop/RedBeardMakes

⭐xTool D1 20W Laser Kit - https://www.xtool.com/products/portable-diode-laserbox-d1-for-laser-engraving-laser-cutting-b?ref=RedBeardOps&utm_source=influencer&variant=43022796554479

⭐ xTool Air Assist - https://www.xtool.com/products/air-assist-set?ref=RedBeardOps&utm_source=influencer

🛠 Notable Items and Tools:
12x12x1/4 Wood - https://amzn.to/3y5VSFE
Honeycomb Table (400x400mm) - https://amzn.to/3RmYaba
Amazon Link To XTOOL - https://amzn.to/3qsZbCG

#xtool #lasercuttingmachine #laserengraving

00:00 - Fusion 360
03:43 - Fusion 360 to Lightburn
09:05 - Finding Right Settings
11:54 - Cutting Out Stand
14:46 - Results

**********************************************************
A Notice from Red Beard Ops LLC:
The information provided on this channel is for entertainment purposes only. Any action you as the viewer takes upon the information on this channel is strictly at your own risk, and Red Beard Ops LLC will not be liable for any losses, damages, or personal injuries in connection with the use of this content (including injuries, damages, or losses sustained while you were trying to emulate the actions and projects on this channel). Attempting to emulate any of the actions or projects put forth by this channel should not be done without training and even then, at your own risk.