Flooring Installation Don't Railroad Materials

Save
3 years ago
22

Why when you're installing flooring, especially in a mobile home you always want to run your layers of materials across each other.

⏱️⏱️Chapters⏱️⏱️
00:00 Intro
00:22 Mobile home factory caused a problem with floors
00:45 Why is that such a bad habit
01:05 You have a gap that runs across the floor cause by railroading
01:20 How he does the floors and why.
01:40 Never want to run all materials with the floor joists
01:57 Follow us

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: [email protected]
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

#MobileHomeRepair, #MobileHomeImprovement, #diyhomerepair

Transcription:
So what we're dealing with is. Actually, a problem that was inherited from design, uh, on the floor, the, the factory ran, long sheets lengthways. Instead of across, that's really bad habit, because the particleboard and the plywood, uh. Runs their layers this way also. So inherently it's weaker. And it will bow in between. It doesn't help that it had water on it.

But if you’ll notice that there's a little bit of a gap right there, uh, say a quarter inch, and it goes all the way across that particular area. But here where it got just a little bit of water, of course it's much, much worse. So what we're going to do is pop lines, and I'll probably replace material. And guess what? I'm not going to be running the material lengthways, even if it's only 16 inches wide, I'm going to run 16 inch butt cuts across it. That way, the strength.

Is running this direction across an area because that way. So you always you never want to do what they call railroading, which is to run your material lengthways with the floor joists. You want to go across the floor joists. So, you're still on the strength of the floor joists, going this way and the plywood going this way. Weaving it. It’s making both of them stronger.

So that's what we're going to do.

Loading comments...