Should you buy a chiller? Bucket vs Chiller for Co2 Laser Cooling

Should you buy a chiller? bucket vs Chiller for laser engraving. In this video, we do a side-by-side experiment to see If it is worth it for a small shop to buy a chiller for your laser engraver. We did a very small project and the bucket temps went from 26.5 to 28.2C while the chiller started at 27.5 and claimed to 27.7. Chiller did a better job in maintaining temps. and after a month of using the Chiller, we have had more consistent cuts that result in better cuts.

Monport Laser Link
If you are interested in this model of laser engraver Please use the link https://bit.ly/3qL49ev and the Viewer discount code Timothy6.
if you want this chiller
https://monportlaser.com/collections/accessories/products/9l-industrial-water-cooling-system-cw-3000

Interact with us
Email:[email protected]
https://www.buymeacoffee.com/CoupleofBunkys
eBay Listings for walking sticks.
https://www.ebay.com/usr/bunkyswo94
Etsy store
https://www.etsy.com/shop/BUNKYSWOODWORKING?ref=seller-platform-mcnav
https://www.instagram.com/coupleofbunkies/
The Rumble page is
https://rumble.com/c/c-616185
Facebook page is
https://www.facebook.com/Bunkyswoodworking
Twitter is
https://twitter.com/CoupleBunkys
If you want to support us directly watch our video on
BITCHUTE and click the tip or pledge page is
https://www.bitchute.com/channel/XLesXaIRu5Nl/
or support us on Patreon
https://www.patreon.com/CoupleofBunkies/membership
Follow us on Tiktok
https://www.tiktok.com/@bunkyswoodworking?lang=en

00:00 Introduction
00:47 Research
01:45 Reaching out to monport
02:03 setting up and running the experiment
04:08 Conclusion You decide