Belt Sander Grinder DIY. I made it Using Only Simple Tools.

Hello everyone🙌.
I built this belt sander using a simple power tool and junk I found in the workshop. I'm sure you can do the same, or even better!
Work process:
To make a drive roller without using a lathe, I took plywood and a jigsaw.
The plywood is strong enough and is perfect as a drive roller.
I cut the circles of the desired diameter with a jigsaw and glued them together with wood glue. For greater reliability, I pulled these circles with two long self-tapping screws.
Then I fixed this workpiece on the motor shaft and using an angle grinder and a chisel, gave a round shape to my workpiece.
I made the driven roller using several bearings and a bolt.
I made the frame of the grinder from a sheet of iron 6 mm thick.
I showed the whole process in the video, I think you will like it!

FRIENDS ATTENTION!

I started a new channel on YouTube.
This channel is all about cooking!
Mostly male food! Everything we like - more meat, and without unnecessary troubles!
Please support my endeavor! Follow the link, look at a couple of recipes, I'm sure you'll like it!
Thank you!
https://www.youtube.com/channel/UCjWqeIua4jzuPkXP2WBAAuA

#BeltSander
#DIYProject
#DIY