First print !

Ordered the printer on Wed afternoon.
It arrived Friday morning at 11:30.
Set it up most of Friday evening and Sat

First prints Sunday Afternoon (after church)

Sunday was double check day. We found the filament sensor plugged into the wrong port.

Startup checks found an x-axis travel problem. The tie-wraps on the extruder were preventing full travel.

And the printer blower and the hotbed fan were ‘swapped’. (Swapped them twice…probably gave the wrong answer to the question the first time, so we had to swap back…)

And then we had z-axis height issues. Adjusted the PINDA the wrong way.