Should Romex Be Stapled Neatly? DOES IT MATTER??

We electricians hear about this phrase "do all electrical work in a workman like manner" from the NEC, so here's my thoughts about how it applies to the aesthetics of running Romex (NM cable).

👾🤖PRACTICE EXAMS🤖👾
https://www.electricianu.com/practice-exams

😎👕MERCH👕😎
https://www.electricianu.com/merchandise

📲👥SOCIALS👥📲
Instagram - https://www.instagram.com/electrician_u
Discord - https://discord.gg/7ykYfbh
Facebook Page - https://www.facebook.com/theelectricianu
Facebook Group - https://bit.ly/2tz7eQh
TikTok - https://www.tiktok.com/@electricianu

There are two schools of thought out there from a lot of electricians, have to think it doesn't matter what the wires look like because they're going to get covered up by sheet rock and the other half think everything that you do matters and that you should take pride in everything that you do. But I offer up a third option, take time and do things well but don't take so much time that you're wasting money.

A great electrician is somebody that can efficiently do correct work as quickly and neatly as possible. The reason people choose to hire professional companies because they can do amazing work in a very short amount of time, and because they've built a reputation on doing quality work. I'm from the school of thought that all of the work that I do needs to impress me. If it impresses me it will most likely impress other people. And the people that I want to impress or my customers, and inspectors.

When you just slap things together in a very sloppy manner it makes an inspector want to take a closer look at everything you do because they realize you are just a fast worker and you don't care about the quality of what your work looks like to others. So if you don't care about what other people think of your work you're not going to care what you think of it either. I think it's extremely important to care about the quality that you provide as an electrician.

Article 334 of the NEC talks about all of the different approved means of stapling Romax, and nowhere in there does it state it needs to be neatly stapled. The only mention of stapling is to make sure that flat cables are not stapled on edge, rather they are stacked on their flat edges on top of each other. This leaves a lot of leeway for strapping. This can cause a problem however because people tend to put far too many pieces of Romax together when running them through walls or securing them in groups. There is a rule for bundling conductors and you do have to D rate your conductors if you put too many of them together in any lengths exceeding 24 inches. Many people don't do this, and it's going against code when they do...regardless of how pretty it looks.

Doing work that looks neat is great, however, doing work that meets code is the higher priority. I do think both can be achieved, and that is what a great electrician should strive for.

#romex #electrician #stapling
--
Subscribe - https://www.youtube.com/c/electricianu?sub_confirmation=1

IF YOU ENJOY THESE VIDEOS PLEASE SUBSCRIBE AND "LIKE" THEM ABOVE. ALSO CHECK OUT THE ELECTRICIAN U PODCAST ON ITUNES AND SPOTIFY!!