3018 PRO - Making a spoilboard

In this episode we create a spoilboard for our 3018Pro complete with slots so we can still use clamps.

Link to the files used and Grahams tutorial - remember you will need to unzip all the files:
https://1drv.ms/u/s!AuoE9S3Cr4VZgpceKgIoUrZQbSyrNg?e=fY7DXY

List of tools:
Surfacing bit - https://amzn.to/3syuknD
6.5mm or 1/4" collet insert - https://amzn.to/3vcjd4W
Collet set (optional) - https://amzn.to/2PCCKvt
1/8th flat end mill - https://amzn.to/3cybCH9
V bit - https://amzn.to/3sz1Biz
Blue tape - https://amzn.to/3u9UT2R
Starbond - https://amzn.to/3fpEtze
Direct from Starbond with 10% off, code is Jamesdean10
https://www.starbond.com/?rfsn=5289219.1383e8

To become Patreon and help the channel please check out the link below.
https://www.patreon.com/JamesDeanDesigns

If you want to help but do not want to become a Patreon, you con contribute directly:
https://www.paypal.me/jamesdeandesigns

Some product links I use are affiliate links. This means they do not cost you any more but I might make a small commission in return which helps towards making these videos.