DIY Homemade CNC - 80/20 Tumbler V2 Introduction - Neo7CNC.com

Help support Neo7CNC:
https://www.paypal.me/neo7cnc

http://www.neo7cnc.com
Follow me on twitter http://www.twitter.com/neo7cnc

Milling Specs:
25,000 RPM
1/4 inch "O" flute Onsrud aluminum cutting endmill
Mister

Rough:
30 ipm
0.05 DOC

Finish:
15 ipm
0.0035 pass

This is part one of Tumbler V2. The 1st version one was overloaded by the 5 pounds of stainless steel media I put in it. This new design will be larger and very sturdy. I plan on using the same motor to start with and will replace it if it's not up to the challenge.