Snowmobile Suspension Stops

This short picture series of aluminum blocks that are for the rear suspension of a snowmobile and were too small to do what the owner wanted them to do which was limit suspension travel so the snowmobile would not lift the skis so high. He wanted the two sides which were created by the factory for use to stay the dimension they were, and wanted me to add approximately ¾” on one side, and 1” on the other side. I had some ¼” x 1” aluminum flat stock and used it as the original block was 1” thick, this being said I had to grind out between each piece so I would get good penetration as I was to mill the welds down to the blocks original thickness which would remove most of the weld. The blocks would not have any kind of stresses on them that would tear them apart just pressure pushing them together. After assembling all the pieces to add to each left and right hand blocks, I had to weld them to the factory blocks and mill them down to size. Below are the addresses my YouTube channel which I no longer have access to, my Instagram page, HRI Services welding Facebook page, and my Outdoor Pursuits Facebook page.

https://www.millerwelds.com/
https://www.doorcounty.com/
https://www.usa.canon.com/
https://www.youtube.com/@HRIservicesllcSturgeonBay
https://www.instagram.com/hri_services/
https://www.facebook.com/HRIServicesllc/
https://www.facebook.com/groups/218766029078898