PushBlock Work Hold Clamp For My CNC Router Talbe

I designed these to fit a 2X2 inch grid of 1/4 inch holes on my CNC router table.

Get yours Here
https://www.etsy.com/JackInTheShop/listing/1453713942/set-of-2-pushblock-cnc-work-hold-clamps?utm_source=Copy&utm_medium=ListingManager&utm_campaign=Share&utm_term=so.lmsm&share_time=1682332648086

To set up your spoil board to use these clamps, create a grid of 2in holes on center. It is recommended to do a test of 4 holes in scrap to ensure proper alignment in the vertical and horizontal positions. Do not use an endmill to drill the holes. What I used and is the suggested bit to use, the Lightning Series ¼" Carbide Drill form IDC Woodcraft.

Get Extreme-Performance with the IDC Woodcraft 1/4 Drill Bit to prep your spoil board for the Push Block Work Hold Clamp https://link.idcwoodcraft.com/hqatlj