Flashforge Dreamer (NX) - Polymaker Gold PETG 1.75mm Filament Testing - Part 2

This two-part video shows the testing of Polymaker Gold PETG 1.75mm Filament and compares it to Hatchbox Gold PETG which I review in the next set of videos.

Part 1 shows unboxing, and using a Temperature Tower to evaluate the best extrusion temperature to use as well as a Bed and Layer Adhesion Test to evaluate the best bed temperature and cooling profile to get the best results. Extrusion problems, mean I had to change out the heat break tube and try again in Part 2.

Part 2 covers further Bed and Layer Adhesion testing, printing 3dBenchy for a fun print which shows the problems of using 0% fan with PETG, and finishes with using it to print a new product: a tray to hold the Sabacc Pot for the Star Wars Sabacc (poker) game. I compare the Polymaker PETG to Hatchbox PETG (review coming up next) to make the product and shows the winner.

Link to Sabacc Pot Tray on my Etsy Store:
https://www.etsy.com/listing/1261118300/sabacc-pot-tray-pspa-approved

Link to Polymaker Gold PETG Filament 1.75mm on Amazon:
https://smile.amazon.com/gp/product/B09H2SHPD9/

Link to Temperature Tower Thingiverse Project:
https://www.thingiverse.com/thing:4356906

Link to Bed Adhesion and Layer Cracking Test
https://www.thingiverse.com/thing:4536632

Link to 3dBenchy on Thingiverse:
https://www.thingiverse.com/thing:763622

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

OpenSCAD website:
https://www.openscad.org/

I used Simplify3D slicer software for the test:
https://www.simplify3d.com/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
Music:
"Blippy Trance" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 4.0 License
http://creativecommons.org/licenses/by/4.0/

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video