5 years ago

Wilga is my third homemade/ DIY RC model, I built in in 2013. Some have
request for me to release the build video. The first version is very detailed and
very hard to make, especially the tail boom part, because in the first version
the tail boom is fully cylindrical. It's also quite heavy around 1200 gram, so in
this latest version I already made the plans easier to build and only has 900
gram AUW even with larger wing area. The first one is 1300 mm this one is
1400 mm wingspan. However the test flying was not very smooth, there were
some trials and also a crash. But luckily it was easy to repair and I made the
nose a bit longer to remove the heavier counter weight ballast.

SUBSCRIBE and Like to support this channel
#wilga #rcplane #buildvideo

You can download the plans on the link below :
A4 Plans : https://paper-replika.com/RCplans/PR_Wilga_A4.pdf
A0 Plans : https://paper-replika.com/RCplans/PR_Wilga_A0.pdf
A3 Decal : https://paper-replika.com/RCplans/Wilga_decal.pdf

Build instructions :
https://paper-replika.com/index.php/rc-foam-project/pzl-104-wilga-rc-plane

DONATE via Paypal : [email protected]

Playlist :
02:42 Plans Preparation
03:36 Wing
08:48 Fuselage
14:36 Landing Gear
19:42 Covering
21:46 Control Surfaces
24:24 Electronic and Wing Mounting
30:15 Engine Cowl
32:47 Finishing
37:20 Maiden Flight
49:06 Next Project?

Specs :
1. Wingspan 1400mm / 55 inches
2. Flying weight : 900 grams/ 31.7 oz
3. Wing loading : 35.7 g/dm2 - 11.7 oz/sq.ft
4. Wing cube loading : 7.1
5. Wing Area : 25.2 dm2 / 391 sq.in
6. CG : 5.25 cm from LE

Electronics
- Turnigy 2830 1000kv brushless motor
- ESC 40A
- Battery Lipo 3S 2200mah - Li-ion 3S 3300 mah
- 4 plastic gear 9 gram servos
- Propeller : 10x5

Materials :
1. 5mm & 10mm Depron/ Polyfoam
2. 3mm Plywood
4. 0.3mm Mica Plastic
5. hot glue + CA glue + UHU glue
6. white packing tapes https://amzn.to/3ttYTMp

Tools :
1. Covering iron https://amzn.to/38YZyMh
2. Heat gun https://amzn.to/3A1cvkR
3. Hot glue gun https://amzn.to/38XyrkY

Loading comments...