Patching sheet metal on the edge of a chevy blazer quarter panel

The rear quarter panel of my K5 blazer had been previously rust patched and repaired with body filler. I am removing all the body filler from this truck and teaching myself how to straighten all the bodywork by learning metal working techniques along the way. In this case, a previous repair from an offroad accident in Moab Utah needed to be replaced and so I show how I cut the area out, formed a patch that goes around a tight edge and then welded it in.

http://www.bdpknox.com

If you would like to see some of my earlier videos on the same truck, check these out:

How I made the shrinking pliers: https://youtu.be/RX5pyUncGyk

How I made a wooden clamping block: https://youtu.be/h54ZZtk7Vgg

How I made a hammer form: https://youtu.be/KVCuWbVYbgc

Hammer and dolly: https://youtu.be/GcK7O5nm_zc

Shrinking disc: https://youtu.be/kCKVejMQqao

TIG welding: https://youtu.be/KwjkODBF4OI

#firstgen #chevy