⚠ Easy Test - 3D Printer Calibration - Extruder Calibration Calculator - E Steps Calculator

⚠ Easy Test - 3D Printer Calibration - Extruder Calibration Calculator - E Steps Calculator

🔴 Subscribe to my channel: https://www.youtube.com/channel/UC0d-p0Fhqs0cDN2JeVzdg6Q?sub_confirmation=1
🎁 My Patreon page: https://www.patreon.com/3DParts4U (Get access to my 3D models)
🎧 My Spotify playlists: https://open.spotify.com/user/schipperrene?si=06d90570db5f48f6

A quick 3D printer extruder calibration test!
See if your printer pushes out enough, too much or too little filament.

Send the following 3-line G-code to your 3D printer (SD card or USB drive):

>>

T0 ; Select left extruder
M109 S180 ; Set temperature and wait for left extruder
G1 E100 F150

<<

G1: a linear movement
E100: an extrusion of 100mm length of filament
F150: speed is 150mm per minute

👉 More about G-codes: https://marlinfw.org/docs/gcode/G000-G001.html
👉 Image used: https://unsplash.com/photos/pAATRR5q30A

My steps per mm were set on 147 and that was the right number.
What if it wasn't the right number?

I added a marker at 100mm from the inlet and it stopped exactly there.
So it extruded 100mm as intended with the g-code.

What if it stopped 10mm before it? Then it extruded 100-10 = 90mm instead of 100mm. The steps per mm (E-steps) should be 147*100 = 14700 / 90 = 163,3 instead of 147.

Repeat the steps above until 100mm length of filament is extruded after sending the code.

🔈 Nu Disco Funk by WinnieTheMoog
Free download: https://filmmusic.io/song/6169-nu-disco-funk
Licensed under CC BY 4.0: https://filmmusic.io/standard-license

#AllVisuals4U #3DParts4U #Tutorial #Tutorials #3DCAD #CAD #3D
#HowTo #Wiki #Manual #Help #Tips #Tricks #3DPrinting #3DPrinted #3DPrinter
#PLA #Filament #Filaments #3DPrints #CoolPrints #Beginner #Guide #Help #Start
#YoutubeShorts #Shorts #Short #ShortStories #ShortVideo #ShortsVideos #ShortsVideo #Reels #Calibration #ExtruderCalibration #Calculator #ESteps

🌐 Visit my website: https://www.3dpartsforyou.com

🔩 Subscribe to my channel AllVisuals4U | Design & Engineering: https://www.youtube.com/@AllVisuals4U
🔩 All playlists of AllVisuals4U | Design & Engineering: https://www.youtube.com/@AllVisuals4U/playlists

📦 Subscribe to my channel 3DParts4U | 3D Printing For Everyone: https://www.youtube.com/@3dparts4u
📦 All playlists of 3DParts4U | 3D Printing For Everyone: https://www.youtube.com/@3dparts4u/playlists

⚡ Subscribe to my short format channel: https://www.youtube.com/@AllVisuals4UShorts
⚡ All playlists of the short format channel: https://www.youtube.com/@AllVisuals4UShorts/playlists