Progress On QEG

Good day folks, Here is a basic circuit diagram, So far I find two modes of operation, Continuous Trigger mode, This is the most expected and tame results so far.

The other mode is Passive Self Oscillation mode, It's an experimental mode in the works.

The passive version works flonky, Seems the coupling to be complete random , shocks me across the room and burns out all my reactive stages.

In passive mode, Everytime the transistors triggers the dump, it creates feedback radiant energy, coupling back into it, The reverse 120 cap along with the electret effect ramps back up with this amplified amplitudes, and triggers the transistor again and it goes on and on but in between these dumps it triggers these random sharp spikes of over 1kV and it's taking out every PSU I tried using this energy on in this mode..... To failure every time. (when it does decide to work) Lots of heat and burning up at the PSU stage. Coil still runs cold.... It looks like something in random couples into this to help aid the effect, But only once triggered ironically. It's does not appear at this point available 24.7 varies in the daytime and night time. Some hours it won't seem to even trigger the loop while other times with no effort it goes for hours. Flashes neons, runs Bedini motors etc...But quicky burns out the PSU stage so I advise experimenting in this mode until we find out more about it. I really hurt my hand with this shock. And it was not a typical shock. It "reached" out and grabbed my nearby finger near the transistor, kept shocking me even as I took my finger a few inches away. Felt like it was pulling my finger "in" And my whole hand hurts today! So CAUTION!

Forum http://typeright.social/forum

Please Help Support My Research: https://youtu.be/pYXETBB40j0