High Power Crystal Cell

Here I was trying to build a gel cell and found these polymer based just add water beads for decoy and candles. I noticed a chemical reaction by just adding the PEG powder without water. The beads quickly disintegrated into a translucent thin slime. So I doped my magnesium anode plate in this so that it was just a thin layer like it only looked like it was wet. I put the carbon on top and of course at the time dead short so I kept it there. And a few hours later I get all this crystal formation and I can hear it popping and see it expanding out. It's already dry. As I did not add any water to this mix.

I tested the cell and it reads 1.6 volts at the time of the video and puts out 13ma and holds under dead short even. It can even run a small motor without any capacitor "tricks" This is 6.5 times more than the cupcake cell.

It seems one hour after this video the cell is still active growing and is giving higher voltages of 1.8 volts. Might try to build the John Hutchison crystals cell design with the pipes and doping with this mix instead.