1 year ago

Automotive Full Throttle Cars Short Ram Air Intake (Employer) cold air intake intake manifold gasket replacement intake manifold intake manifold leak symptoms intake manifold gasket intake synonym how to filter

Introduction:
Embarking on the installation of a Short Ram or Cold Air Intake system can be an exhilarating project for car enthusiasts seeking enhanced performance and a distinctive engine sound. However, it's crucial to approach this task with utmost care, as improper installation can lead to serious injuries or damage to your vehicle. This step-by-step guide provides instructions for the installation process, but remember: You undertake this project at your own risk. The following steps should be followed with precision and caution, and any deviation may result in adverse consequences.

Disclaimer:
WARNING/Attention: I am not responsible for any injuries or damage that may occur during the installation process. Undertake this project at your own risk. If you are unsure or uncomfortable with any step, seek professional assistance.

Materials Needed:

Short Ram or Cold Air Intake Kit
Basic hand tools (screwdrivers, pliers, etc.)
Jack and jack stands
Safety glasses and gloves
Vehicle owner's manual
Step 1: Prepare Your Work Area
Park your vehicle on a flat surface and engage the parking brake. Ensure you have enough space to work around the engine bay and that all necessary tools are readily available. Wear safety glasses and gloves to protect yourself during the installation.

Step 2: Disconnect the Battery
To prevent electrical mishaps, disconnect the negative terminal of the vehicle's battery. Refer to your owner's manual for guidance on safely disconnecting the battery.

Step 3: Locate the Factory Intake System
Identify the existing air intake components in your vehicle. This may include the air filter box, intake tubing, and mass airflow sensor (MAF).

Step 4: Remove the Factory Intake
Carefully disassemble the stock intake system by loosening clamps, removing bolts, and disconnecting any sensors. Keep track of the hardware for later use.

Step 5: Install the Short Ram/Cold Air Intake
Follow the manufacturer's instructions included with your intake kit to install the new components. Pay close attention to the correct placement of the air filter, MAF sensor, and tubing.

Step 6: Secure and Tighten
Ensure all connections are secure, and tighten clamps and bolts to the manufacturer's specifications. Be cautious not to overtighten, as this may damage components.

Step 7: Reconnect the Battery
Reconnect the negative terminal of the battery and double-check that all connections are secure.

Step 8: Start the Engine
Start your vehicle and listen for any unusual sounds. Check for any air leaks or loose components. If everything appears normal, allow the engine to run for a few minutes and then turn it off.

Final Note:
Remember, this guide is provided for informational purposes only, and any installation should be done with extreme care. If you are uncertain about any step, seek professional assistance. Install the Short Ram or Cold Air Intake at your own risk, and be mindful of your vehicle's warranty and emissions regulations.

WARNING/Attention: I am not responsible for any injuries or damage that may occur during the installation process. Undertake this project at your own risk. If you are unsure or uncomfortable with any step, seek professional assistance.

* TOOL'S YOU WILL NEED FOR THIS INSTALL
1) Clip Pullers
2) 10mm Socket/Wrench
3) Tweezers
4) Flat-head Screwdriver
5) Sharp Scissors/saw

* Product Purchased
https://www.pepboys.com/product/details/20059551/01666/2010/FORD/FUSION/0/4-2488%25202.5L%2520DOHC

* Follow me on all of my Social Media's
1) Facebook - https://www.facebook.com/theeundead.youmadbro?viewas=100000686899395&privacy_source=timeline_gear_menu&sw_fnr_id=3799289633