Baseball Bat Stools

I received an email from a client asking if I could make 4 barstools of out some of his old baseball mlb bats.

I attempted to discuss and show the process I went through to build these stools.
The holes are drilled at 11 degrees with my drill press. The bats are cut at the same angle.
I allowed the bats to protrude through the seats and then used a pull saw to flush trim them.
I created a blog explaining as much of the process as possible on my website. That blog will be posted shortly.

Tools Used:
@HarveyIndustriesIntl Alpha 4 HP table saw
@JessEmToolCompany Router Table
@BoschNA 1617 Router - https://amzn.to/3O8NPQ1
@grizzlymachines Band Saw
Porter Cable Drill Press
@cmtorangetools CMT 806.690.41B Xtreme Compression Flush Trim Bits 2 Flutes Carbide Tipped - https://amzn.to/3APRcYV
@rubiomonocoatusa -Pure -https://amzn.to/40JmI5F

Chapters
0:00 Introduction
0:08 Band Saw and Seat Layout
0:48 Router Table and Flush Trim Bit
1:08 Drill Press and Forstner Bit
1:40 Table saw explanation
4:06 Cutting Bats
4:32 Rubio Monocoat finish application
16:35 - Finish Product and Wrap up