U-Joint Install, Grinding The Welds, Tail Shaft Installed, Prop Shaft & Save The Wooly Worm!

After welding the rear wheel bearings to the axle shaft there is, of course, some grinding that must be done. I fitted the rear prop shaft U-Joint, tail shaft, propeller shaft/drive shaft, I'm not too sure why I'd need the spacer behind the rear bearing but it can't hurt to fit it so I got a lally column (between the rabbited lattices at the lintels) and drove it up behind the welded in bearings.

Save The Wooly Worm! Why do they wish to crawl up into the barn where they are sure to expire? Earthworms do the same. Must be the common worm factor.

Please only do what I do at your own risk.

I have some information on Odysee too if you'd like to check that out and I also post these on Rumble and X.

As Bob Witherspoon said: "Poor People Can't Afford Cheap Stuff"

I have No sponsors at all.