Aussiecams - HOW to HARDWIRE your Dashcam EASY STEP BY STEP parking mode activation

Send us a video - www.transfer.pcloud.com use [email protected] as the recipients address.
We cannot use recorded screen footage or transfers via msngr

Video is a guide to HARDWIRE your dashcam, step by step!
Every install is different so we try to show you the breakdown and process of elimination of what circuits to use or avoid.
If you are unsure of what a fuse is for, don't touch it. When running the cabling up to or from the dash cam be sure to avoid any obstruction of airbags. As in the video only run it around the door rubber cavity.
This process can be used on any vehicle and the hardwire kit can be removed for re-installation.

Explanation of the hard-wiring coloured wires
Typically
BLACK - Ground or negative wire
RED - Constant power or positive wire
YELLOW - ACC wire or trigger wire, as you turn ignition from on/off this briefly activates to tell your dashcam to switch in and out of parking mode

Parts required -
2 x 'add a fuse' or piggyback fuses
2 x 5 amp fuses
1 x spade or ring terminal for earth wire

Tools needed
1 x 12 volt circuit tester (or multimeter)
1 x pair of Pliers
1 x utility knife - strip wire if needed

If you have any questions, put in comments or message us here [email protected] and will be answered between 9am-5pm Monday to Friday.

#aussiecams #australiandashcam #hardwire #dashcamhardwire #howtoinstalldashcam

To submit your footage from Australia upload here - www.transfer.pcloud.com and use [email protected] as the recipients email address - quick and easy as sending an email!