Click Programming Software Shortcuts

The Click programming software will allow you to type the instruction abbreviation directly into the ladder at the cursor position.
There is an auto-complete feature on these shortcuts, so when there are no other possible combinations it will display the instruction dialog box.
You can also type certain data addresses directly. For a normally open contact, you can type any address for an input (X001), output (Y001), internal contact (C1), Timer (T1), or Counter (CT1).
For a coil, you can type any address for an output (Y001).

Instruction keyboard shortcuts include:
NO (F2) Normally Open
Ctrl+F2 Immediate
NC (F3) Normally Closed
Ctrl+F3 Immediate
Shft+F2 Raising Edge
Shift+F3 Falling Edge
=, !, (Greater or Less Than) Compare Contact
OUT Out coil
SET Set coil
RESET Reset coil
TMR Timer
CNT Counter
MATH Math
DRUM Drum
SR Shift Register
COPY Copy Data
SRCH Search
CALL Call Sub-routine
FOR For loop
NEXT Next instruction
END End instruction
RD Network Read
SD Network Send

The Click and Click PLUS PLC series can be found at this URL:
https://accautomation.ca/series/click-plc/

There are several reasons why we are using the Click and Click PLUS PLCs. Here are just a few.
- Investment is low for the hardware and the software is free
- Standalone PLC with built-in I/O
- Communication ability - Ethernet Port, RS232, RS485 - support for protocols such as Modbus RTU, Modbus TCP, etc.
- Ability to expand the system with a variety of modules including RTD and Thermocouple inputs directly.

ACC Automation
https://accautomation.ca/