Smooth your ABS and ASA Parts with Acetone

Don't burn your house down - be smart. Keep in mind this method is NOT THE BEST or safest method. There are easier methods, especially ones that have fans, which are linked below. This is just what I do, since I was asked on Twitter, and figured I would share. This is how I was taught to do it at my old job, and have personally preferred it. But be sure to watch the two videos below:

Great alternative way to vapor smooth your parts - watch this especially for larger parts: https://www.youtube.com/watch?v=NiG1jDEG0kA

Dos and Don'ts of vapor smoothing: https://www.youtube.com/watch?v=ZzSGkvdES54

Videos mentioned:
Polysher with Polysmooth: https://www.youtube.com/watch?v=ifukFfCSqU4
Clear Prints with Polysmooth: https://www.youtube.com/watch?v=92C10-n21Po
Clear Prints 2 with Polysmooth: https://www.youtube.com/watch?v=XALChxPG2SY

Designs used:
Skull: https://www.thingiverse.com/thing:441087
Handsome Squidward: https://www.patreon.com/3DPrintGeneral
Pew Pews: The Gatalog

Parts Used (affiliate)
PolyLite ASA: https://amzn.to/2YUDUHp
PolyLite ABS: https://amzn.to/3lilyrn

Time Stamps:
Intro - 00:00
Warnings - 00:26
Setup and Tests- 3:11
Larger Tests - 7:44
Final Thoughts - 11:04

Background Music by Joakim Karud http://soundcloud.com/joakimkarud

My go-to PLA is Polymaker PolyLite PLA. Not a paid sponsor - I just love using it! https://amzn.to/348020l

Follow now for more free giveaways and 3D printing tutorials! Visit http://3dprintgeneral.com/ for products I have used in the past and approve.
You can also rep 3D printing and support the channel via my Merch Store: http://bit.ly/2GidwfQ

Grab the 2020 Edition of my 3D Printing Failures book: https://amzn.to/2pQGOfc
Purchase at a discount at my Patreon: http://bit.ly/2xBSDbY